Snapshot

It is important to make the right decision about the capacity and type of the equipment that will be installed. To determine this, it is desirable or necessary to execute a measurement in advance.

​​​​​​​In some cases a simple snapshot will be sufficient. More sophisticated applications (in case of a harmonic filtering) demand a more profound measurement to come to a suitable solution.

For both kind of measurements, instantaneous or detailed, Comar Benelux has the appropriate equipment and know how.

  • Are there a lot of disturbances and unexpected interruption of the current in your installation ?
  • You want to check if your consumption of electricity is correct ?
  • You want to know the electrical parameters of a specific consumer ?
  • You want to know if your installation is conform to the concept of "Power Quality" ?                         
Meettoestel uitgebreide registratie op lange termijn
Meettoestel voor momentopnameMeettoestel dat registreert op lange termijn

Net analysis

On all these questions a net analysis is the right answer !

We come in site with pleasure and begin with an investigation of the situation. Some instantaneous measurements are taken, followed by the installation of the equipment.

After this detailed analysis, a rapport and some graphics are made. This rapport gives an overview of the situation and eventual problems and allows to propose an adequate solution. 

What is measured ?

  • Line voltage - phase voltage - three phase voltage - current per phase + neutral
  • Thee phase current - power factor - three phase power factor - cosine phi - three phase cosine phi
  • Active power - three phase active power - apparent power - three phase apparent power
  • Reactive power - three phased reactive power - power frequency - voltage harmonics
  • Current harmonics -  minimum and maximum values with time indication
POWER FACTOR CORRECTION UNITS – HARMONIC FILTERS – ELECTRICAL NETWORK ANALYSIS